How Thick Can You Apply Lime Render?

How thick can you apply lime render? Apply the render with a trowel to a maximum thickness of 12mm. If a 12mm coat is not thick enough to create a level surface, add an extra coat(s) as required. Scratch the surface of any underlying coats with the diamond pattern as before.

How long does lime render take to dry before painting?

Lime render or plaster needs to be fully cured before painting. As a general guide allow at least 1 month curing for every 5mm of thickness. In poor drying conditions this time period may be extended.

How do you skim coat lime plaster?

How do I skim onto old plaster? Remove old limewash and sand off any wall papering residues. If a conventional paint has been used this must be removed. A devil float should be used to key the old plaster and slurry coat made from finish plaster and water and applied with a brush.

How thick should render coats be?

Traditional renders should be applied in 2 coats. The first coat should not exceed 15mm thickness and the second coat should be 5-7mm. The first coat should be slightly stronger than the second coat.

Does lime mortar shrink?

not properly compressed - In the first few days after pointing is applied as it carbonates a degree of shrinkage will occur and this is quite normal.


Related guide for How Thick Can You Apply Lime Render?


Can you paint lime plaster?

Lime render or plaster needs to be fully cured before painting. The best person to advise you is your lime provider, however as a general guide allow at least 1 month curing for every 5mm of thickness. In poor drying conditions this time period may be extended.


How do you test lime render?


Can you lime render on plasterboard?

Solo Onecoat Lime Plaster can be used on a wide range of substrates including plasterboard, masonry and Woodfibre insulation panels, which can then be painted over.


Was this post helpful?

Leave a Reply

Your email address will not be published.